Laboratory Design Guidelines – PDF Download

Manostaxx
Manostaxx – Indusrial Management Consulting

http://www.manostaxx.com

INTRODUCTION
Purpose: UNC-Chapel Hill has a continuing need to modernize and upgrade its facilities. The resulting
construction projects often have significant health and safety requirements due to regulatory oversight. Since  these requirements can impact the design of a project, the Department of Environment, Health and Safety (EHS)  prepared this EHS Laboratory Design Guide to aid the campus community with planning and design issues.

EHS believes that the Guide, in conjunction with EHS’s plan review and consultation, improves design
efficiency and minimizes changes. The main number for the UNC-EHS Office is (919) 962-5507.
Application: The Guide is a resource document for use by faculty, staff, and design professionals for use
during the planning and early design phases of a project. The Guide applies to construction projects for all  UNC-Chapel Hill facilities, including leased properties.

Format of Guide: The Guide is formatted to address laboratory design issues pertinent to General Laboratories  (e.g.: chemical laboratories) in Section II through VII, with additional requirements for Radioactive Materials  Laboratories and Biosafety Level 2 Laboratories presented in Sections VIII and IX respectively. Within the  sections, specific design criteria are provided.

References: Please note that if any Design Guidelines are less stringent than the current NC Building Code,  Mechanical Code, Fire Prevention Code etc., it should be brought to the attention of the EHS Department for  discussion and revision as necessary. The Design Guidelines are not intended to preempt NC Code without  State approval of Alternate Methods and Materials, where these Guidelines are found to be less stringent.

Design criteria are designated in the following ways:
Shall: Criterion is typically mandated by applicable regulation(s). The user of the Guide is required to
include the design feature.

Must: Criterion is based on well-established consensus standards//guidelines. “Must” is used to reflect a UNC requirement, although not required by a regulation.  The use
the design feature.

Should: Criterion is advisory in nature, based on good engineering and safety practices. It is the discretion  of the user of the Guide to include the design feature.

Limitations of the Guide: The EHS Laboratory Design Guide is not “all inclusive.” It does not cover all
regulatory issues nor does it cover all design situations. It is important to note that use practices must be  considered during the design process, as they can directly influence how the laboratory will be designed (e.g..  how hazardous materials are used impacts how they are stored, which is a design issue). In all cases, EHS should  be consulted on questions regarding health, safety, and the environment.

 

Download PDF here

Continue at:  https://facilities.unc.edu/files/2016/03/Laboratory-Design-Guidelines.pdf

The text above is owned by the site above referred.

Here is only a small part of the article, for more please follow the link

Also see:

https://dadoswebaxx.weebly.com/

Web Data Extraction
Web Data Extraction

Leave a Reply

Your email address will not be published. Required fields are marked *